If you are looking for information on how to find a roof, you probably know that the "transom" is the conclusion of a beam hanging on a wall. What you may not know is the location you chose. He can determine whether you have trodden on the roof or not.
If you are planning to install a circuit board, you basically have two options. You can contact roofing companies online.
Image Source: Google
How to design a roof – cut vertical beams
Cut vertical blocks with vertical plates. This is useful for attaching gutters as the back of most gutters is also vertical. However, without gutters, a lot of the water coming from the roof will flow into the street, where the wood can rot over time, especially at the joints.
However, a much bigger problem was that the guard angle was on the sloping roof. It varies significantly with slope, but the drop limit is usually only 1 angle, which can be 90 degrees. Obviously, the blanket may have limitations for the habit of dripping, but more often it is "made" along with conventional things, trying to bend it by hand in place to adjust the angle.
How to design a roof – a square cut beam
The rib rods are cut square vertically to the stem. This will lower them and move away from the edge of the droplet. And when the gutter is not used, water can leak from the edge of the drip without touching the plate.